No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Duplex Modes of Ethernet

Duplex Modes of Ethernet

The physical layer of Ethernet can work in either half-duplex or full-duplex mode.

  • Half-duplex mode

    The half-duplex mode has the following features:

    • Data can only be sent or received at any time.

    • The CSMA/CD mechanism is used.

    • The maximum transmission distance is limited.

    Hubs work in half-duplex mode.

  • Full-duplex mode

    After Layer 2 switches replace hubs, the shared Ethernet changes to the switched Ethernet, and the half-duplex mode is replaced by the full-duplex mode. As a result, the transmission rate increases greatly, and the maximum throughput doubles the transmission rate.

    The full-duplex mode solves the problem of collisions and eliminates the need for the CSMA/CD mechanism.

    The full-duplex mode has the following features:

    • Data can be sent and received at the same time.

    • The maximum throughput doubles the transmission rate.

    • This mode does not have the limitation on the transmission distance.

    All network cards, Layer 2 devices (except hubs), and Layer 3 devices produced support the full-duplex mode.

    The following hardware components are required to realize the full-duplex mode:

    • Full-duplex network cards and chips

    • Physical media with separate data transmission and receiving channels

    • Point-to-point connection

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 79649

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next