No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the MUX VLAN Function on a Port

Enabling the MUX VLAN Function on a Port

Context

After the MUX VLAN function is enabled on a port, the principal VLAN and subordinate VLAN can communicate with each other; ports in a group VLAN can communicate with each other; ports in a separate VLAN cannot communicate with each other.

Pre-configuration Tasks

Before enabling the MUX VLAN function on a port, complete the following task:
  • Adding the port to a principal or subordinate VLAN as an access, hybrid, or trunk interface

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port link-type { hybrid | access | trunk }

    The port link-type is set.

  4. Run port mux-vlan enable vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    The MUX VLAN function is enabled.

    After the MUX VLAN function is enabled on an interface, VLAN stacking and VLAN mapping cannot be configured on the interface.

    NOTE:
    • Access interfaces can be added to only one MUX VLAN group. Trunk and hybrid interfaces can be added to multiple MUX VLAN groups. An interface can be added to a maximum of 32 MUX VLAN groups.

    • The interface enabled with the MUX VLAN function cannot be added to other VLANs of the MUX VLAN group.
    • Disabling MAC address learning or limiting the number of learned MAC addresses on an interface affects the MUX VLAN function on the interface.

    • The MUX VLAN and port security functions cannot be enabled on the same interface.

    • In a cascading scenario, the MUX VLAN cannot be enabled between interfaces connecting access and aggregation devices.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 116539

Downloads: 289

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next