No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VLAN Aggregation

VLAN Aggregation

Figure 5-21 Networking diagram of VLAN aggregation application

As shown in Figure 5-21, four VLANs, namely, VLAN 21, VLAN 22, VLAN 31, and VLAN 32, are configured. If these VLANs need to communicate with each other, you should configure an IP address for each VLAN on the Switch.

Alternatively, you can enable VLAN aggregation to aggregate VLAN 21 and VLAN 22 into super VLAN 2, and VLAN 31 and VLAN 32 into super VLAN 3. Therefore, you can save IP addresses by only assigning IP addresses to the super VLANs.

After Proxy ARP is configured on Switch, the sub-VLANs in each super VLAN can communicate with each other.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125087

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next