No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of MSTP Configuration Tasks

Summary of MSTP Configuration Tasks

Table 10-8 lists the MSTP configuration tasks.

Table 10-8 MSTP configuration tasks
Item Description Task

Configuring Basic MSTP Functions

MSTP is configured on switching devices to trim a ring network to a loop-free network. Devices start spanning tree calculation after the working mode is set and MSTP is enabled. Use any of the following methods if you need to intervene in the spanning tree calculation:
  • Manually configure the root bridge and secondary root bridge.
  • Set a priority for a switching device in an MSTI.
  • Set the path cost for a port in an MSTI.
  • Set a priority for a port in an MSTI.

Configuring Basic MSTP Functions

Configuring MSTP Multi-Process

On a network deployed with Layer 2 single-access rings and multi-access rings, configure multiple MSTP processes so that spanning trees of different processes are calculated independently and do not affect each other.

Configuring MSTP Multi-Process

Configuring MSTP Parameters on an Interface

Proper MSTP parameter settings achieve rapid convergence.

Configuring MSTP Parameters on an Interface

Configuring MSTP Protection Functions

One or more MSTP protection functions can be configured.

Configuring MSTP Protection Functions

Configuring MSTP Interoperation Between Huawei Devices and Non-Huawei Devices

To communicate with a non-Huawei device, set proper parameters on the MSTP-enabled Huawei device.

Configuring MSTP Interoperation Between Huawei Devices and Non-Huawei Devices

Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 159487

Downloads: 326

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next