No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for GVRP

Application Scenarios for GVRP

GVRP enables switches on a network to dynamically maintain and update VLAN information. With GVRP, you can adjust VLAN deployment on the entire switching network by configuring only a few devices. Analyzing the topology and managing configurations are not necessary. In Figure 8-5, GVRP is enabled on all devices. Devices are interconnected through trunk interfaces and each trunk interface allows packets of all VLANs to pass. Using GVRP, you simply need to configure static VLANs 100 to 200 on SwitchA and SwitchB. Other devices can then learn VLANs 100 to 200 using GVRP. Department A then can communicate with Department B. The VLAN deletion is similar.

Figure 8-5 Typical application
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125043

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next