No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for Link Aggregation

Default Settings for Link Aggregation

Table 3-4 Default settings for link aggregation

Parameter

Default Setting

Link aggregation mode

Manual load balancing mode

Upper threshold for the number of active member links

8 on the CE5810EI, 32 on the CE6870EI and CE6875EI, 64 on the CE6880EI, and 16 on other models. In the SVF, the maximum number of active interfaces is 8.

Lower threshold for the number of active member links

1

LACP system priority

32768

LACP interface priority

32768

LACP preemption

Disabled

LACP preemption delay

30s

Timeout interval at which LACPDUs are received

90s

Preferentially forwarding local traffic on an Eth-Trunk

Enabled

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 115893

Downloads: 288

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next