No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring STP Multi-Process

(Optional) Configuring STP Multi-Process

Context

STP multi-process is used for independent calculation of spanning trees between M-LAG access devices. After STP multi-process is enabled, some M-LAG member interfaces on M-LAG devices can be managed in each process. Devices perform STP calculation based on processes, and the interfaces that are not in processes do not participate in STP calculation of processes. This speeds up STP convergence.

NOTE:

STP multi-process must be configured simultaneously on M-LAG master and backup devices, including the number of processes, process ID, and the status of STP. Otherwise, the V-STP function cannot be used.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run stp process process-id

    An STP process is created and the STP process view is displayed.

  3. Run stp mode { stp | rstp }

    The working mode of the STP process is configured.

    By default, the working mode of an STP process is MSTP. V-STP does not support the MSTP mode, so the V-STP mode needs to switch to STP or RSTP. When a switch starts, the default STP process with the ID of 0 exists. STP configurations in the system view and interface view belong to STP process 0.

  4. Run stp enable

    MSTP of the STP process is enabled.

    By default, STP in a process is disabled.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 81430

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next