No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Link Aggregation Configuration

Verifying the Link Aggregation Configuration

Procedure

  • Run the display eth-trunk [ trunk-id [ interface interface-type interface-number | verbose ] | brief ] command to check the Eth-Trunk configuration.
  • Run the display eth-trunk membership trunk-id command to check information about Eth-Trunk member interfaces.
  • Run the display load-balance profile [ profile-name ] command to check the load balancing profile of the Eth-Trunk.
  • Run the display forward eth-trunk mode command to check the number of LAGs supported by the device.
Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 116748

Downloads: 289

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next