No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Link Aggregation in Manual Load Balancing Mode

Link Aggregation in Manual Load Balancing Mode

Link aggregation can work in manual load balancing or Link Aggregation Control Protocol (LACP) mode. The main difference between the two modes is whether LACP is used.

In manual load balancing mode, you must manually create an Eth-Trunk and add member interfaces to the Eth-Trunk. LACP is not used. In this mode, all active links load balance traffic evenly. If an active link fails, the other active links share the traffic evenly. The manual load balancing mode is suitable in scenarios where the link between two directly connected devices requires a high bandwidth but the devices do not support the LACP protocol.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 116168

Downloads: 288

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next