No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating a Super-VLAN

Creating a Super-VLAN


Before configuring a super-VLAN, ensure that sub-VLANs have been configured.


A super-VLAN consists of several sub-VLANs. A VLANIF interface can be configured for the super-VLAN and assigned an IP address (no physical interface can be added to a super-VLAN).


  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    A VLAN is created, and the VLAN view is displayed.

    The VLAN ID of a super-VLAN must be different from every sub-VLAN ID.

  3. Run aggregate-vlan

    A super-VLAN is created.

    A super-VLAN cannot contain any physical interfaces.

    VLAN 1 cannot be configured as a super-VLAN.

  4. Run access-vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    A sub-VLAN is added to a super-VLAN.

    Before adding sub-VLANs to a super-VLAN, ensure that these sub-VLANs are not configured with VLANIF interfaces.

    The device supports 256 sub-VLANs in a super-VLAN.

  5. Run commit

    The configuration is committed.

Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125111

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next