No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the STP/RSTP Mode

Configuring the STP/RSTP Mode

Context

Huawei devices support three working modes: STP, RSTP, and MSTP. STP and RSTP are not compatible with each other. Therefore, on a ring network, enable either STP or RSTP.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run stp mode { stp | rstp }

    The working mode of the device is set to STP or RSTP.

    By default, the working mode of a device is MSTP. MSTP is compatible with STP and RSTP.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 97252

Downloads: 276

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next