No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using Eth-Trunk to Connect Two Access Switches to a Core Switch

Using Eth-Trunk to Connect Two Access Switches to a Core Switch

As shown in Figure 3-14, access switches SwitchB and SwitchC of the data center connect to core switch SwitchA. SwitchB and SwitchC connect to many users, and SwitchA connects to the external network through the egress router. More and more users connecting to the network want to communicate with each other. The links between SwitchA and SwitchB, and between SwitchA and SwitchC require sufficient bandwidth and reliability. Eth-Trunk 1 and Eth-Trunk 2 are then created to provide high bandwidth and reliability.

Figure 3-14 Eth-Trunk networking

You can determine the working mode for the Eth-Trunk according to the following situations:

  • If devices at both ends of the Eth-Trunk support LACP, the LACP mode is recommended.

  • If the device at either end of the Eth-Trunk does not support LACP, you must use the manual load balancing mode.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 118358

Downloads: 292

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next