No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Minimum Frame Length and Maximum Transmission Distance

Minimum Frame Length and Maximum Transmission Distance

Due to the limitation of the CSMA/CD algorithm, an Ethernet frame must be longer than or equal to a specified length. On the Ethernet, the minimum frame length is 64 bytes, which is determined jointly by the maximum transmission distance and the collision detection mechanism.

The use of minimum frame length can prevent the following situation: station A finishes sending the last bit, but the first bit does not arrive at station B, which is far from station A. Station B considers that the line is idle and begins to send data, leading to a collision.

Figure 1-2 Ethernet_II frame format

The upper layer protocol must ensure that the Data field of a packet contains at least 46 bytes, so that the total length of the Data field, the 14-byte Ethernet frame header, and the 4-byte check code at the frame tail can reach the minimum frame length, as shown in Figure 1-2. If the Data field is less than 46 bytes, the upper layer must pad the field to 46 bytes.

Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 126064

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next