No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Principal VLAN for a MUX VLAN

Configuring a Principal VLAN for a MUX VLAN

Context

Ports added to a principal VLAN can communicate with every port in the MUX VLAN.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    A VLAN is created, and the VLAN view is displayed. If the specified VLAN has been created, the VLAN view is directly displayed.

    The VLAN ID ranges from 1 to 4094 (VLANs 4064 to 4094 are default reserved VLANs. You can run the vlan reserved command to configure the reserved VLAN range). If VLANs need to be created in batches, run the vlan batch { vlan-id1 [ to vlan-id2 ] } &<1-10> command to create VLANs in batches, and then run the vlan vlan-id command to enter the view of a specified VLAN.

    NOTE:

    If a device is configured with multiple VLANs, configuring names for these VLANs is recommended:

    Run the name vlan-name command in the VLAN view. After a VLAN name is configured, you can run the vlan vlan-name vlan-name command in the system view to enter the corresponding VLAN view.

  3. Run mux-vlan

    The VLAN is configured as a principal VLAN.

    The VLAN ID assigned to a principal VLAN can no longer be used to configure any VLAN Stacking, VLAN Mapping, super-VLAN, or sub-VLAN.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 125191

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next