No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the TPID Value in an Outer VLAN Tag

Configuring the TPID Value in an Outer VLAN Tag

Context

To enable interoperation between devices from different vendors, set the same TPID value in outer VLAN tags on the devices. Devices from different vendors or in different network plans may use different TPID values in VLAN tags of VLAN packets. To adapt to an existing network plan, the switch supports TPID value configuration. You can set the TPID value on the switch to be the same as the TPID value in the network plan to ensure compatibility with the current network.

NOTE:
  • To implement interoperability with a non-Huawei device, ensure that the protocol type in the outer VLAN tag added by the switch can be identified by the non-Huawei device.
  • The qinq protocol command identifies incoming packets, and adds or changes the TPID value of outgoing packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run qinq protocol protocol-id

    The protocol type in the outer VLAN tag is set.

    The qinq protocol command cannot be used on Dot1q-tunnel interfaces.

    The TPID value can be 0x8100, 0x9100, or 0x88a8.

    By default, the TPID value in the outer VLAN tag is 0x8100.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 81148

Downloads: 274

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next