No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Network Diameter

Setting the Network Diameter

Context

Any two terminals on a switching network are connected through a specific path along which multiple devices are located. The network diameter is the maximum number of devices between any two terminals. A larger network diameter indicates a larger network scale.

An improper network diameter may cause slow network convergence and affect communication. Setting a proper network diameter according to the network scale helps speed up network convergence.

The switch calculates the Forward Delay, Hello Time, and Max-Age based on the configured network diameter. It is recommended that you set the network diameter to configure timers.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run stp vlan vlan-id [ to vlan-id ] [ vlan-id [ to vlan-id ] ] &<1-9> bridge-diameter diameter

    A network diameter is set.

    By default, the network diameter is 7.

    • Rapid Spanning Tree Protocol (RSTP) uses a single spanning tree instance on the entire network. As a result, performance deteriorates when the network scale grows. Therefore, the network diameter cannot be larger than 7.

    • It is recommended that all devices on a ring network use the same network diameter.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 124947

Downloads: 295

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next