No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, MUX VLAN, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an mVLAN to Implement Integrated Management

Configuring an mVLAN to Implement Integrated Management

Context

Management VLAN (mVLAN) configuration allows users to use the VLANIF interface of the mVLAN to log in to the management switch to centrally manage devices. To use a network management system to manage multiple devices, create a VLANIF interface on each device and configure a management IP address for the VLANIF interface. You can then log in to a device and manage it using its management IP address. If a user-side interface is added to the VLAN, users connected to the interface can also log in to the device. This brings security risks to the device.

After a VLAN is configured as an mVLAN, no access interface or dot1q-tunnel interface can be added to the VLAN. An access interface or a dot1q-tunnel interface is connected to users. The mVLAN forbids users connected to access and dot1q-tunnel interfaces to log in to the device, improving device performance.

Pre-configuration Tasks

Before creating a VLANIF interface, complete the following tasks:

  • Create a VLAN.

  • Associate the VLAN with the physical interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

    NOTE:

    If a device is configured with multiple VLANs, configuring names for these VLANs is recommended:

    Run the name vlan-name command in the VLAN view. After a VLAN name is configured, you can run the vlan vlan-name vlan-name command in the system view to enter the corresponding VLAN view.

  3. Run management-vlan

    An mVLAN is configured.

    After an mVLAN is configured, an interface added to the mVLAN must be a trunk or hybrid interface.

    VLAN 1 cannot be configured as an mVLAN.

  4. Run quit

    The VLAN view is quit.

  5. Run interface vlanif vlan-id

    A VLANIF interface is created and the VLANIF interface view is displayed.

  6. Run ip address ip-address { mask | mask-length } [ sub ]

    The IP address of the VLANIF interface is configured.

    After assigning an IP address to the VLANIF interface, you can run the stelnet command to log in to a management switch to manage attached devices.

  7. Run commit

    The configuration is committed.

Verifying the Configuration

  • Run the display vlan command to check information about the mVLAN. The command output shows information about the mVLAN in the line started with an asterisk sign (*).

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004351

Views: 126732

Downloads: 296

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next