No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Service

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DNS, IP performance optimization, IPv6, DHCPv6, and IPv6 DNS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Layer 2 Proxy ARP

Configuring Layer 2 Proxy ARP

Layer 2 proxy ARP can effectively isolate broadcast domains and reduce the impact of ARP broadcast messages on the network.

Pre-configuration Tasks

Before configuring Layer 2 proxy ARP, complete the following tasks:

Configuring link layer protocol parameters for interfaces to ensure that the link layer protocol on the interfaces is Up

CE6880EI does not support the function.

Configuration Procedure

Figure 2-14 Flowchart of configuring Layer 2 proxy ARP

Updated: 2019-05-08

Document ID: EDOC1100004354

Views: 69486

Downloads: 147

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next