No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DNS, IP performance optimization, IPv6, DHCPv6, and IPv6 DNS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Aging Time of Dynamic PMTU

Setting the Aging Time of Dynamic PMTU

Context

When the device functions as a source node and sends packets to a destination node, the device dynamically negotiates the PMTU with the destination node according to the IPv6 MTU values of interfaces and fragments packets based on the PMTU. After the PMTU ages out, the dynamic PMTU is deleted. The source node dynamically renegotiates the PMTU with the destination node.

NOTE:

When both static and dynamic PMTUs are configured, only static PMTU takes effect. Static PMTU entries never age.

The interface MTU, IPv6 interface MTU, and PMTU are valid only for packets generated on the device, not for packets forwarded by the host.

A switch can receive ICMPv6 error packets that are sent from other devices and learns the path MTU according to the received ICMPv6 error packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Configure the IPv6 MTU for an interface.

    1. Run interface interface-type interface-number

      The specified interface view is displayed.

    2. (For Ethernet interfaces) Run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

      The command fails if any Layer 2 configuration exists on the interface. In such a case, clear the Layer 2 configurations on the interface before running the undo portswitch command.
      NOTE:

      You can run the undo portswitch batch interface-type { interface-number1 [ to interface-number2 ] } &<1-10> command in the system view to switch the working mode of multiple Ethernet interfaces in batches.

    3. Run ipv6 enable

      The IPv6 function is enabled on the interface.

      By default, the IPv6 function is disabled on an interface.

    4. Run ipv6 mtu mtu

      The MTU of IPv6 packets on an interface is set.

      By default, the MTU of IPv6 packets on an interface is 1500 bytes.

      NOTE:
      After the MTU value is changed, run the shutdown and undo shutdown commands or the restart (interface view) command to restart the interface and allow the changes to take effect.
    5. Run quit

      The system view is displayed.

  3. Run ipv6 pathmtu age age-time

    The aging time is set for dynamic PMTU entries.

    By default, the aging time of dynamic PMTU entries is 10 minutes.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004354

Views: 68750

Downloads: 147

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next