No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DNS, IP performance optimization, IPv6, DHCPv6, and IPv6 DNS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the DNS Service and NetBIOS Service on the DHCP Client

(Optional) Configuring the DNS Service and NetBIOS Service on the DHCP Client

Context

To ensure normal operations of DHCP clients, you can specify the DNS server address and the NetBIOS server address when the DHCP server assigns an IP address to the DHCP client.NetBIOS:Network Basic Input Output System. When a DHCP client uses the NetBIOS protocol for communication, host names must be mapped to IP addresses. Based on the modes of obtaining mapping, NetBIOS nodes are classified into the following types:
  • b-node: indicates a node in broadcast mode. This node obtains mappings in broadcast mode.

  • p-node: indicates a node in peer-to-peer mode. This node obtains mappings by communicating with the NetBIOS server.

  • m-node: indicates a node in mixed mode. An m-node is a p-node that has some broadcast features.

  • h-node: indicates a node in hybrid mode. An h-node is a b-type node enabled with the end-to-end communication mechanism.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip pool ip-pool-name

    The IP address pool view is displayed.

  3. Run domain-name domain-name

    The DNS domain name to be assigned to a DHCP client is configured.

  4. Run dns-list ip-address &<1-8>

    The IP address of the DNS server is configured for a DHCP client.

    To load balance the traffic and improve network reliability, configure multiple DNS servers. Each address pool can be configured with a maximum of eight DNS server addresses.

  5. Run nbns-list ip-address &<1-8>

    The IP address of the NetBIOS server used by the DHCP client is assigned.

    Each address pool can be configured with a maximum of eight NetBIOS server address.

  6. Run netbios-type { b-node | h-node | m-node | p-node }

    The NetBIOS node type of the DHCP client is configured.

    By default, no NetBIOS node type is specified for DHCP clients.

  7. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004354

Views: 69355

Downloads: 147

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next