No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DNS, IP performance optimization, IPv6, DHCPv6, and IPv6 DNS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Specify the Number of IPv6 Addresses or IPv6 Routes (with Prefixes Longer Than 64 Bits) Permitted on a Switch

(Optional) Specify the Number of IPv6 Addresses or IPv6 Routes (with Prefixes Longer Than 64 Bits) Permitted on a Switch

Context

Before configuring IPv6 addresses or IPv6 routes with prefixes longer than 64 bits on the switches of the following models, run the assign forward ipv6 longer-mask resource command and specify the number of IPv6 addresses or IPv6 routes with prefixes longer than 64 bits permitted on certain devices.

The models include CE8800 series, CE7800 series, CE6860EI, CE6856HI, CE6855HI, CE6851HI, CE6850U-HI, CE6850HI, CE5855EI, and CE5850EI.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run assign forward ipv6 longer-mask resource ipv6-address-number

    The number of IPv6 addresses and routes with prefixes longer than 64 bits supported by the switch is specified.

    By default, the number of IPv6 addresses or IPv6 routes with prefixes longer than 64 bits permitted on a switch is not specified.

    NOTE:

    When the system resource mode is large routing (configured using the system resource command) on the device, the value of ipv6-address-number can only be 1024.

  3. Run commit

    The configuration is committed.

    NOTE:

    You must run the save command to save the configuration and run the reboot command to restart the device to make the configuration take effect.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004354

Views: 69026

Downloads: 147

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next