No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between CFM and EFM

Configuring Association Between CFM and EFM

Context

For details about principles and usage scenarios of association between EFM and CFM, see CFM Association.

Association between EFM and CFM is bidirectional. When EFM detects a link fault, it will notify CFM of the fault. When CFM detects a link fault, it will notify EFM of the fault.

Pre-configuration Tasks

Before configuring association between EFM and CFM, complete the following tasks:

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run oam-mgr

    The OAM management view is displayed.

  3. Run the following commands as required.

    • Unidirectional association

      Run oam-bind ingress efm interface interface-type interface-number egress cfm md md-name ma ma-name

      EFM is configured to report faults to CFM.

      Run oam-bind ingress cfm md md-name ma ma-name egress efm interface interface-type interface-number

      CFM is configured to report faults to EFM.

    • Bidirectional association

      Run oam-bind cfm md md-name ma ma-name efm interface interface-type interface-number

      EFM and CFM are configured to report faults to each other.

    NOTE:

    Running two commands to configure association functions in opposite directions is equivalent to running the command to configure the bidirectional association function.

    If the oam-bind cfm md md-name ma ma-name efm interface interface-type interface-number command is run, oam-bind ingress efm interface interface-type interface-number egress cfm md md-name ma ma-name and oam-bind ingress cfm md md-name ma ma-name egress efm interface interface-type interface-number will be displayed in the configuration file.

    After EFM is associated with other functional modules, pay attention to the following points:
    • If EFM is disabled on an interface, association between EFM and other functional modules is deleted.
    • If an MA or MD is deleted, association between CFM and other functional modules is deleted.

  4. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004359

Views: 66421

Downloads: 129

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next