No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Timeout Period of the DelayDown Timer

(Optional) Setting the Timeout Period of the DelayDown Timer

Context

If a DLDP interface in Active, Advertisement, or Probe state receives a Port-Down event, the interface enters Inactive state and clears the neighbor information. In some cases, the interface is Down for a short time. For example, failure of the Tx fiber on an interface may cause jitter of optical signals on the Rx fiber, which makes the interface Down and then Up again. To prevent the neighbor information from being deleted immediately in this case, the DLDP interface first enters the DelayDown state and starts the DelayDown timer. Before the DelayDown timer times out, the interface retains the neighbor information and responds to only Port-Up events.

  • If the DLDP interface does not receive any Port-Up event when the DelayDown timer times out, the interface enters the Inactive state and deletes the neighbor entry.

  • If the DLDP interface receives the Port-Up event before the DelayDown timer times out, the interface returns to the previous state.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run dldp delaydown-timer time

    The timeout period of the DelayDown timer is set.

    The default timeout value of the DelayDown timer is 1 second.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004359

Views: 65456

Downloads: 128

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next