No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Multiple Masters Coexist in a VRRP Group

Multiple Masters Coexist in a VRRP Group

Fault Description

Multiple masters coexist in a VRRP group.

Procedure

  1. Ping masters to check network connectivity between masters.

    • If the ping operation fails, check whether the network connection is correct.

    • If the ping operation is successful and the TTL value of the ping packet is 255, go to step 2.

  2. Run the display vrrp virtual-router-id command in any view to check whether the masters use the same virtual IP address, interval at which VRRP Advertisement packets are sent, authentication mode, and authentication key.

    • If the configured virtual IP addresses are different, run the vrrp vrid virtual-router-id virtual-ip virtual-address command to set the same virtual IP address.

    • If the intervals are different, run the vrrp vrid virtual-router-id timer advertise advertise-interval command to set the same interval.

    • If the authentication modes and keys are different, run the vrrp vrid virtual-router-id authentication-mode { simple { key | plain key | cipher cipher-key } | md5 md5-key } command to set the same authentication mode and key.

      NOTE:

      For security purposes, you are advised to use MD5 as the authentication algorithm of VRRP.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004359

Views: 61128

Downloads: 128

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next