No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Uplink and Downlink Interfaces in a Monitor Link Group

Configuring the Uplink and Downlink Interfaces in a Monitor Link Group

Context

An interface cannot be added to a Monitor Link group in the following situations:
  • The interface has been added to a Smart Link group.
  • The interface has been added to another Monitor Link group.
  • A stack port
  • A fabric-port

A Monitor Link group consists of at most 16 uplink interfaces and 512 downlink interfaces.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run monitor-link group group-id

    The Monitor Link group view is displayed.

    The device supports a maximum of 24 Monitor Link groups.

  3. Run port interface-type interface-number { downlink [ downlink-id ] | uplink }

    Or run smart-link group group-id uplink

    An interface is configured as an uplink or downlink interface of the Monitor Link group, or a Smart Link group is configured as an uplink of the Monitor Link group.

    If the downlink interface is configured earlier than the uplink interface, the downlink interface becomes Down. It is recommended that the uplink interface be configured first and then the downlink interface be configured.

    After a Monitor Link group is configured, the uplink interfaces are monitored in real time. When all uplink interfaces fail, all the downlink interfaces in the Monitor Link group are forcibly set to Error-Down state.

    The device records the status of an interface as Error-Down when it detects that a fault occurs. The interface in Error-Down state cannot receive or send packets and the interface indicator is off.

  4. (Optional) Run timer recover-time recover-time

    The wait to restore (WTR) time is set.

    By default, revertive switching of a Monitor Link group is enabled and the WTR time is 3 seconds.

  5. Run commit

    The configuration is committed.

Verifying the Configuration

  • Run the display monitor-link group { all | group-id } command to verify information about the Monitor Link group.

Follow-up Procedure

  • To change the downlink interface status from Error-Down to Up, rectify the fault on the uplink interface. After the uplink interface becomes Up and the automatic switching time is reached, the downlink interfaces become Up.

  • In some situations, for example, an optical module needs to be replaced, you may want to change the uplink status temporarily without affecting the downlink status. To save the trouble, run the monitor-link disable command. After this command is configured, Monitor Link does not change the downlink interface status based on the uplink status.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004359

Views: 66051

Downloads: 129

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next