No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BFD to Detect an Eth-Trunk in a VLAN

Configuring BFD to Detect an Eth-Trunk in a VLAN

Pre-configuration Tasks

BFD for Perlink quickly detects and monitors an Eth-Trunk in a VLAN.

Before configuring BFD to detect an Eth-Trunk in a VLAN, complete the following tasks:

  • Configure an Eth-Trunk and ensure that its link layer protocol status is Up.

  • Add the Eth-Trunk to a VLAN.

  • Allocate an IP address to a VLANIF interface.

Configuration Process

Figure 2-20 Configuring BFD to detect an Eth-Trunk in a VLAN

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bfd

    BFD is enabled globally and the BFD view is displayed.

    By default, BFD is disabled globally.

  3. Run quit

    Return to the system view.

  4. Run bfd session-name bind peer-ip ip-address [ vpn-instance vpn-name ] interface interface-type interface-number source-ip ip-address per-link one-arm-echo

    A BFD session for Perlink is created.

    NOTE:
    • The local and remote BFD discriminators of BFD for Perlink do not need to be configured manually.
    • When using BFD for Perlink, ensure that URPF is disabled on the transmit end of BFD echo packets. Otherwise, the BFD echo function may become invalid.

  5. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004359

Views: 65388

Downloads: 128

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next