No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R003C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BFD for VRRP

BFD for VRRP

If the Virtual Router Redundancy Protocol (VRRP) master fails, the VRRP backup with the highest priority quickly takes over traffic to minimize service interruption.

VRRP determines whether to perform preemption based on the timeout interval of the backup. The switchover takes longer than 1 second. BFD can be used to quickly detect the master status and further minimize traffic interruption. BFD monitors real IP addresses of the master and backup devices during communication. If communication is irregular, the backup device considers the master device to be Down and takes over. A VRRP group implements a rapid active/standby VRRP switchover by tracking the BFD session status. The switchover time is less than 50 milliseconds.

Networking

Figure 2-9 BFD for VRRP

In Figure 2-9, SwitchA and SwitchB establish a VRRP group. SwitchA functions as the master and SwitchB functions as the backup. User traffic is transmitted through SwitchA. SwitchA and SwitchB establish a BFD session and the VRRP group tracks the BFD session status. When the BFD session status changes, the priority is changed for the VRRP group, triggering a rapid active/standby switchover.

The rapid active/standby VRRP switchover process is as follows:
  1. When a BFD session detects a link fault between SwitchA and SwitchC, BFD reports a Down event to VRRP.
  2. The priority of SwitchB increases above the priority of SwitchA.
  3. SwitchB becomes the master switch immediately, and subsequent user traffic is forwarded through SwitchB.
Translation
Download
Updated: 2019-05-08

Document ID: EDOC1100004359

Views: 66593

Downloads: 129

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next