No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei SAP HANA Appliance Single Node Installation Guide (KunLun 9008 and 9016) 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Modifying the hosts File

Modifying the hosts File

NOTE:

For two-node HA or cluster networking, see the corresponding installation guide to modify the hosts file.

Edit the hosts file as follows to enable the HANA server host name and IP address parsing:

  1. Run the vi /etc/hosts command to open the hosts file.

    hw00001: # vi /etc/hosts

  2. Press i to make the hosts file editable and add the following information to the file.

    NOTE:

    In the following information, the host names and IP addresses are examples only. Change them based on the actual situation. The IP addresses must be the service port IP addresses.

    127.0.0.1   localhost localhost.localdomain localhost4 localhost4.localdomain4
    ::1         localhost localhost.localdomain localhost6 localhost6.localdomain6
    10.5.2.10  hw00001 hw00001

  3. Press Esc to switch the vi editor to the CLI mode. Press the colon (:) key to switch to the bottom line mode. Enter wq and press Enter to save the configuration and exit.
Translation
Download
Updated: 2019-08-27

Document ID: EDOC1100004728

Views: 46682

Downloads: 145

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next