No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei SAP HANA Appliance Single Node Installation Guide (KunLun 9008 and 9016) 09

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IP Addresses

Configuring IP Addresses

NOTE:

For two-node HA or cluster networking, see the corresponding installation guide to configure IP addresses.

  1. Use the KVM to log in to the OS CLI by using the user name root and password Huawei123.

  1. Run the vi /etc/sysconfig/network-scripts/ifcfg-enp2s0f0 command to open the network port configuration file to configure the IP address and subnet mask.

    In this example, the network port enp2s0f0 is used. Change it as required.
    [root@hw00001 ~]# vi /etc/sysconfig/network-scripts/ifcfg-enp2s0f0
    TYPE=Ethernet
    BOOTPROTO=static
    DEFROUTE=yes
    PEERDNS=yes
    PEERROUTES=yes
    IPV4_FAILURE_FATAL=no
    IPV6INIT=yes
    IPV6_AUTOCONF=yes
    IPV6_DEFROUTE=yes
    IPV6_PEERDNS=yes
    IPV6_PEERROUTES=yes
    IPV6_FAILURE_FATAL=no
    NAME=enp2s0f0
    UUID=a9770467-b59a-458a-b3c3-91fe63b5ad63
    DEVICE=enp2s0f0
    ONBOOT=yes
    IPADDR=192.168.19.150
    NETMASK=255.255.0.0

  1. Run the service network restart command to restart the network for the configuration to take effect.

    [root@hw00001 network-scripts]# service network restart
    Restarting network (via systemctl):                   [  OK  ]

  1. Run the systemctl stop firewalld and systemctl disable firewalld commands to disable the firewall, so that errors do not occur in subsequent connections through tools such as Xshell.

    [root@hw00001 home]# systemctl stop firewalld
    [root@hw00001 home]# systemctl disable firewalld

  1. Log in to the server using Xshell.

    1. Click the Xshell tool. (If Xshell has not been installed, download and install it from the Internet.)

    2. Run the ssh 192.168.19.150 command and press Enter.

    3. Enter the user name root and click OK.

    4. Enter the password set for the root user during the OS installation, and click OK.

      You have logged in to the OS of the server whose IP address is 192.168.19.150.

Translation
Download
Updated: 2019-06-17

Document ID: EDOC1100004728

Views: 37109

Downloads: 122

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next