No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Huawei SAP HANA Appliance Single Node Installation Guide (KunLun 9008 and 9016) 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the tuned Service

Configuring the tuned Service

  1. Run the following command to configure the sap-hana configuration file used by the tuned service.


    The sap-hana configuration file of the tuned service provided by SLES for SAP 12 includes various hardware configuration, including power regulator and efficiency mode. The configuration in this file will overwrite the OS configuration.

    # zypper install sapconf
    # tuned-adm profile sap-hana
    # systemctl start tuned
    # systemctl enable tuned
    # saptune solution apply HANA (This command applies to SLES 12.2 and later versions but does not apply to SLES 12.1.)

  2. Run the vi /usr/lib/tuned/sap-hana/tuned.conf command, change the value of force_latency to 70, press Esc, and run :wq to save the configuration and exit.

  3. Run the mkdir /etc/systemd/logind.conf.d/ command to create the logind directory.
  4. Run the vi /etc/systemd/logind.conf.d/sap-hana.conf command, add the following two lines, press Esc, and run :wq to save the configuration and exit.


Updated: 2019-08-27

Document ID: EDOC1100004728

Views: 46055

Downloads: 139

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next