No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei SAP HANA Appliance Single Node Installation Guide (KunLun 9008 and 9016) 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Modifying CPU Parameter Settings

Modifying CPU Parameter Settings

  1. Run the cpupower set -b 0 command to configure low latency (maximum performance) for the system.

    cpupower set -b 0

  1. Run the vim /etc/init.d/after.local command to open the after.local file. Then add cpupower set -b 0 to the file to configure the CPU high-performance mode to auto-startup upon power-on.

  1. Run the cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor command to check the CPU working mode.

    performance indicates the high-performance mode.
    HW00001:~ # cat /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor
    performance

  2. Run the cat /proc/cpuinfo |grep MHz command to check the CPU working frequency.

    cat /proc/cpuinfo |grep MHz

Translation
Download
Updated: 2019-08-27

Document ID: EDOC1100004728

Views: 46421

Downloads: 141

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next