Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting SmartLogger Contrast
You can set the SmartLogger contrast on the monitoring panel.
Context
In addition to the method provided in this section, you can also press and hold 
Procedure
- To set the SmartLogger contrast, perform the steps in the following table: The parameter values in the figures are for reference only.
LCD
Procedure
1. On the default screen, press
to enter the main menu.
2. Choose
and press
.
3.Because of permission restriction, log in as Common User, or Advanced User.NOTE:After passing the permission validation, the system keeps the authentication information for 30 seconds. If you exit from the Settings page and log in again within 30 seconds, no authentication is required.
Here use the pages displayed when you log in to the SmartLogger as Advanced User.
4. Choose , and press
.
5. Select and press
.
6. On the Contrast tab, press
and
to set the contrast.
NOTE:The contrast value ranges from zero to ten.
