Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Sending a Reset Command to the Inverter
You can send a reset command to the inverter on the LCD.
Procedure
- The following table describes the procedure for sending a reset command to the inverter. The parameter values in the following figures are for reference only.
LCD
Procedure
1. On the default screen, press
to enter the main menu.
2. Choose
and press
.
3. Select an inverter and press.
NOTE:SUN2000 (1--2) on the left indicates that the inverter connects to Port 1 of the SmartLogger and the communications address of the RS485 port is 2.
4. Choose , and press
.
5. Because of permission restriction, log in as Advanced User.
6. Choose Reset and press
.
7. Press
.
and press 
