Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Power Factor Closed-Loop Control
Before setting the parameters for
power factor closed-loop control, ensure that the power meter is connected
to the SmartLogger. For details, see Connecting the SmartLogger to a Power Meter.
Set Reactive power control mode to Pwr factor closed-loop control.
Figure 8-9 Power factor closed-loop control
![]()
- Target power factor: indicates the target value for the adjustment power factor of the power meter.
- Adjustment interval: indicates the interval for sending adjustment commands by the SmartLogger.
- Adjustment deadband: indicates the adjustment
power factor precision. The specified value of Adjustment deadband takes effect only if the power factor for the power meter exceeds 0.9.
