Setting System Time Parameters
This topic describes how to set the date, time and date format for the SmartLogger on the monitoring panel.
Procedure
- The following table describes the procedure for setting the time and date. The parameter values in the following figures are for reference only.
LCD
Operation Procedure
1. On the default screen, press
to enter the main menu.
2. Choose
and press
.
3.Because of permission restriction, log in as Common User, or Advanced User.NOTE:After passing the permission validation, the system keeps the authentication information for 30 seconds. If you exit from the Settings page and log in again within 30 seconds, no authentication is required.
Here use the pages displayed when you log in to the SmartLogger as Advanced User.
4. Choose , and press
.
5. Choose or by pressing
, and press
.
NOTICE:- Modifying Date&Time will affect the integrity of the SmartLogger's energy yield and performance data. Hence, do not change it at will.
- After Date&Time is successfully set, this time can be synchronized in all the inverters connected to the SmartLogger.
6. On the Date&Time page, set the date and time, set the time zone, enable or disable the daylight saving time, and press
.
To select the specific parameter, click
. To set the parameter value, set
or
.
7. On the Date Format page, select a date format, and press
.
