Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Sending a Reset Command to the PLC (MBUS)
You can send a reset command to the PLC (MBUS) on the monitoring panel.
Procedure
- The following table describes the steps for sending a reset command to the PLC (MBUS). The parameter values in the following figures are for reference only.
LCD
Operation Procedure
1. On the default screen, press
to enter the main menu.
2. Choose
and press
.
3. Select PLC and press.
NOTE:PLC (3-249) in the left figure indicates that PLC is connected to Port 3 of the SmartLogger, whose RS485 address is 249.
4. Choose and press
.
5. Because of permission restriction, log in as Advanced User. 6. Choose and press
.
7. Press
to verify your settings.
