Batch Upgrade
This topic describes how to perform a batch upgrade for the SUN2000 on the monitoring panel.
Context
The SUN2000 that can be upgraded in batches on the SmartLogger must be SUN2000 V100R001C11SPC409, SUN2000 V100R001C81SPC101 and its later patch versions, or SUN2000 V200R001C00 and its later patch versions.
Procedure
- The following table describes the batch
upgrade procedure. The parameter values in the figures are for reference
only.
LCD
Procedure
1. On the default screen, press
to enter the main menu.
2. Choose
and press
.
3. Because of permission restriction, log in as Advanced User or Special User.NOTE:After passing the permission validation, the system keeps the authentication information for 30 seconds. If you exit the screen and log in again within the 30 seconds, no permission authentication is required.
Here use the pages displayed when you log in to the SmartLogger as Advanced User.
4. Choose and press
.
NOTE:- Before this operation, connect the USB flash drive to the USB port.
- The system takes 5 to 10 seconds to detect the USB flash drive. Then perform the following steps.
5. Choose Batch Upgrade and press
.
6. Choose SUN2000 and press
.
7. After checking that Target ver. is correct, press
.
NOTICE:- For the SUN2000, its firmware can be upgraded only if the device status is On-grid or Shutdown. Check the device status before firmware upgrade.
- The upgrade takes 20 minutes when the baud rate is 9600 bps.
- After the upgrade is successful, the SUN2000 automatically restarts.
and press 
