Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Manually Powering On or Off the PID on the monitoring panel
This topic describes how to power on or off the PID on the monitoring panel.
Procedure
- The following table shows the procedure for powering on or off the PID on the monitoring panel. The parameter values in the following figures are for reference only.
LCD
Operation Procedure
1. On the default screen, press
to enter the main menu.
2. Choose
and press
.
3. Select a PID and pressNOTE:PID (3-1) in the left figure indicates that the PID is connected to the Port 3 of the SmartLogger, and its RS485 communications address is 1.
4. Choose Settings and press
.
5. Because of permission restriction, log in as Advanced User. 6. Choose , and press
.
- Perform step 7 if you want to power on the inverter manually.
- Perform step 8 if you want to power off the inverter manually.
7. Power on manually.
a. Choose and press
.
b. Enter
again to verify your settings.
8. Power off manually.
a. Choose , and press
.
b. Enter
again to verify your settings.
