Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Dry Contact Remote Control
- If ports of DI1–DI4 have been configured in Dry contact remote shutdown, Dry contact remote control is unavailable.
- Before setting dry contact remote control, ensure that the SmartLogger connects to a correct ripple control receiver. For details, see Connecting the SmartLogger to a Ripple Control Receiver.
Set Active power control mode to Dry contact remote control. ![]()
Figure 8-4 Dry contact remote control
![]()
- A maximum of 16 levels are supported for the percentages.
- "√" indicates a low level. When connecting to GND1, the four DI ports of the SmartLogger are low-level ports. If not connected, the ports are high-level ports.
- The status combination of DI1(GND1)–DI4(GND1) should differ from each other. Otherwise, abnormal command parsing will occur.
- If the actual input DI signal is inconsistent with that configured on the WebUI, the SmartLogger controls the SUN2000 to work at full power and the Abnormal Active Schedule alarm is generated.