No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R009C00 Local HA System Software Installation Guide (SUSE Linux + MySQL + OMMHA) 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Starting eSight

Starting eSight

You need to run the start command on the active and standby nodes of eSight respectively. eSight can be started successfully only when both the active and standby nodes are started successfully and two-node cluster resource status of eSight is normal. The process of starting eSight takes about 10 minutes.

Procedure

  1. Use Putty to log in to the active eSight server as the ossuser user.
  2. Run the following command to start the eSight system:

    > cd /opt/ommha/ha/bin

    > ./start.sh

    The following information indicates that the operation is performed successfully:

    start HA successfully.

  3. Log in to the standby eSight server as the ossuser user.
  4. Run the following command to start the eSight system:

    > cd /opt/ommha/ha/bin

    > ./start.sh

    The following information indicates that the operation is performed successfully:

    start HA successfully.

  5. Check the two-node cluster status. If the status is normal, eSight is started successfully. Otherwise, contact Huawei technical support.

    1. Log in to the active eSight server as the ossuser user.
    2. Run the following command to query the status of the HA resources.

      > cd /opt/ommha/ha/bin

      > ./status.sh

      Information similar to the following is displayed.

      HAMode  
      double  
       
      NodeName    HostName    HAVersion       StartTime       HAActive    HAAllResOK  HARunPhase 
      ha1         Primaster   V100R001C01 2017-02-22 16:44:01  active      normal      Actived 
      ha2         Secmaster   V100R001C01 2017-02-22 16:46:45  standby     normal      Deactived 
       
      NodeName    ResName     ResStatus       ResHAStatus      ResType  
      ha1          MySQL       Active_normal     Normal      Active_standby  
      ha1         NMSServer     Normal           Normal      Single_active  
      ha1         RMFloatIp     Normal           Normal      Single_active  
      ha2          MySQL       Standby_normal    Normal      Active_standby  
      ha2         NMSServer     Stopped          Unknown     Single_active  
      ha2          RMFloatIp    Stopped          Normal      Single_active    

Download
Updated: 2019-09-02

Document ID: EDOC1100011856

Views: 90885

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next