No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R009C00 Single-Node System Software Installation Guide (SUSE Linux) 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Can I Do If the Server IP Address Cannot Be Displayed During Installation

What Can I Do If the Server IP Address Cannot Be Displayed During Installation

Symptom

During installation, the available IP address is not displayed in the drop-down list box in the window for selecting an IP address.

Possible Causes

The network cables are disconnected.

The driver of the network adapter where the IP address is located has not been correctly installed.

The operating system IP address is not configured.

Procedure

  • In the Linux operating system, run the ifconfig -a command and check whether RUNNING is contained in the command output. If not, connect network cables.

eSightServer:~ # ifconfig -a 
eth0      Link encap:Ethernet  HWaddr 00:50:56:A5:4F:BB 
          inet addr:10.137.59.73  Bcast:10.137.59.255  Mask:255.255.254.0 
          inet6 addr: fe80::250:56ff:fea5:4fbb/64 Scope:Link 
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1 
          RX packets:314327176 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:35814134 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:1000 
          RX bytes:49954752530 (47640.5 Mb)  TX bytes:88316862279 (84225.5 Mb) 

lo        Link encap:Local Loopback 
          inet addr:127.0.0.1  Mask:255.0.0.0 
          inet6 addr: ::1/128 Scope:Host 
          UP LOOPBACK RUNNING  MTU:16436  Metric:1 
          RX packets:210643315 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:210643315 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:0 
          RX bytes:78500362123 (74863.7 Mb)  TX bytes:78500362123 (74863.7 Mb)     
  • Re-install the driver of the network adapter and then re-install eSight.
  • Set the operating system IP address. For the Windows operating system, see Changing the Operating System IP Address in Single-Node System Software Installation Guide (Windows). For the Linux operating system, see Changing the IP Address and Host Name of the Operating System in Single-Node System Software Installation Guide (SUSE Linux).
Download
Updated: 2019-05-17

Document ID: EDOC1100011860

Views: 92757

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next