No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R009C00 Single-Node System Software Installation Guide (SUSE Linux) 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Changing the IP Address and Host Name of the Operating System

Changing the IP Address and Host Name of the Operating System

Reconfigure the host name and IP address of the eSight server operating system based on the plan.

Prerequisites

Stop eSight by referring to Stopping the eSight Service.

Procedure

  1. Log in to the Linux server as the root user.
  2. Run the following command to access the YaST Control Center interface.

    # yast2

    NOTE:

    If the tool window is not displayed in the Linux operating system, rectify the fault according to What Can I Do If the Tool Window Is Not Displayed in the Linux Operating System.

  3. Select System > Network Settings.

  4. Click the Hostname/DNS tab and change the host name as planned.

  5. On the Overview tab, select the IP address you want to change, and click Edit.

  6. Click the Address tab in the Network Card Setup interface that is displayed, change the IP address, enter the host name, and click Next.

    NOTE:

    Enter the host name which is same as the host name in 4.

  7. Click the Routing tab and set the default gateway as planned.

  8. Click OK.
  9. Configure the local host IP address and host name.

    1. Open hosts file.

      # vi /etc/hosts

    2. Press i to enter the editing mode.
      • If two IP address + host name records exist, comment out the incorrect record.
      • If only one IP address + host name record exists, change it to the correct IP address and host name.
      192.168.1.100    eSightServer.site eSightServer 
      NOTE:

      eSightServer indicates the host name of the server. Replace it based on the actual situation.

    3. Press Esc to exit the editing mode and run the :wq command to save and exit the file.
    4. After the modification, run the hostname -i command to check the IP address.

  10. (Optional) Synchronize IP addresses of eSight and the server. For details, see How to Synchronize the eSight Server IP Address to eSight(Linux).
Download
Updated: 2019-05-17

Document ID: EDOC1100011860

Views: 93019

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next