No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R009C00 Single-Node System Software Installation Guide (SUSE Linux) 09

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Can I Do When eSight Installation, Upgrade, or Startup Fails If Required Ports Are Occupied

What Can I Do When eSight Installation, Upgrade, or Startup Fails If Required Ports Are Occupied

Question

If required ports are occupied, eSight installation, upgrade, or startup may fail.

Answer

During eSight installation, upgrade, or startup, multiple operating system ports are used. Ensure that these ports are in idle state. Otherwise, eSight installation, upgrade, or startup may fail.

For details about eSight port planning and usage, see the eSight Communication Matrix.

To release used ports, perform the following operations.

  • Windows
    1. Access the CLI and run the following command to check the IDs of the processes that occupy ports (Here, take port 21 as an example):
      netstat -ano | findstr :21

      Information similar to the following is displayed:

      NOTE:

      Here, 820 indicates the ID of the process that occupies port 21.

    2. Run the following command to stop the process (after the process is stopped, port 21 is in idle state):
      taskkill /F /PID 820
    3. Perform eSight installation, upgrade, or startup again.
  • SUSE Linux:
    1. Access the CLI and run the following command to check the ID of the process that occupies port 21:
      netstat -anp|grep :21

      Information similar to the following is displayed:

      NOTE:

      Here, 324 indicates the ID of the process that occupies port 21.

    2. Run the following command to stop the process.
      kill -9 324
    3. Perform eSight installation, upgrade, or startup again.
Download
Updated: 2019-05-17

Document ID: EDOC1100011860

Views: 92217

Downloads: 138

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next