No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R009C00 Operation Guide 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Operation Procedure

Operation Procedure

This section describes how to perform compliance check on devices using eSight, helping you quickly master compliance check operations.

Table 12-52 Compliance Check Operations

Step

Operation

Description

1

Set protocol parameters on the device: SNMP and Telnet

  • If SNMP is used, the MIB view including ISO nodes must be configured. SNMPv2c read and write permissions are mandatory.

    For details about how to configure the SNMP protocol on the device, see Configuring the SNMP Protocol on Devices.

  • The Telnet privilege mode on eSight must be the same as that on the device.

    For details about how to set Telnet parameters on the device, see Setting Telnet Parameters on Devices.

2

Add devices to eSight.

Select a proper device addition mode based on the site requirements.

For details about how to add devices to eSight, see Adding Devices to eSight.

3

Perform compliance check.

Set check rules based on service requirements on the live network. Alarms can be set. When detecting a rule that fails to pass the check, eSight triggers an alarm.

Performing Compliance Check

  1. Choose Resource > Network > Configuration > Compliance Check from the main menu.

  2. Choose Task Management from the navigation tree on the left, click , and set basic task information and audit rules.

    Before setting audit rules for devices, you need to add the devices to eSight and set rules based on the detailed examples on the Help tab page of the imported audit rule template.

  3. Check the audit result. (The compliance check task is automatically executed after creation.)

    The audit result can be exported.

Translation
Download
Updated: 2019-09-07

Document ID: EDOC1100011877

Views: 333513

Downloads: 667

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next