No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R009C00 Operation Guide 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Data Maintenance

Data Maintenance

If vCenter server system protocol parameters are changed or system data of eSight and vCenter server is different due to a restart of eSight, manually adjust the parameter settings or synchronize data to ensure data consistency between eSight and vCenter server.

Setting Protocol Parameters

If the parameters of communications protocols in the vCenter server system are modified, eSight must make the same modifications; otherwise, communication exceptions may occur, causing a failure to monitor the vCenter server system.


  1. Choose Resource > Virtual Resources from the main menu.
  2. Choose Virtual Resources > vCenter Server in the navigation area on the left.
  3. Click the name of a vCenter server you want to modify to access its resource manager.
  4. Set SOAP parameters.

    1. Choose Settings > SOAP Protocol Parameters in the navigation area on the left.
    2. Enter the new user name and password.
    3. Click Test to verify the user name and password. If they are incorrect, change them and test again.
    4. Click Apply.

    In the case of incorrect SOAP parameter settings, vCenter server may get offline.

Manually Synchronizing Alarms

vCenter server is disconnected from eSight due to the network. After they are connected again, manually synchronize alarms that are generated during the disconnection period.


  1. Choose Fault > Alarm Synchronism from the main menu.
  2. Click Synchronize NE.
  3. In the dialog box that is displayed, choose Group by NE type > vCenter Server.
  4. In the Available Alarm Sources area, select the vCenter server to synchronize.
  5. Click Confirm.

    The synchronization state and result will be displayed on eSight.

Manually Synchronizing Resource Data

If resources change on devices, you can manually synchronize the latest resource information from the devices.


  • There are component changes on servers used for virtualization, for example, server disk and memory changes, to enable capacity scale-out and scale-in.
  • The network between eSight and vCenter server control nodes is down. As a result, resources cannot be synchronized.


  1. Choose Resource > Virtual Resources from the main menu.
  2. Choose Virtual Resources > vCenter Server in the navigation area on the left.
  3. Select the devices to be synchronized and choose Synchronize Data > Start Synchronization above the list.

    Figure 11-11 Resource data synchronized successfully

Updated: 2019-09-07

Document ID: EDOC1100011877

Views: 333940

Downloads: 667

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next