No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R009C00 Operation Guide 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


This section describes precautions on using the SVF configuration management function so that eSight can be used properly.

License Support

Basic functions and features are not controlled by licenses.

Component Dependency

The SVF configuration management depends on the Network Device Management Component.

Protocol Support

SNMP and STelnet/Telnet are required.

Device Support

Only Huawei devices are supported. For details, see the Specification List.

Version Support

For details, see the Specification List.

Application Scenario

The SVF system, SVF port, and SVF maintenance services need to be end-to-end configured.

Feature Limitation and Dependency

  • Network configuration adjustment may cause network interruption and must be performed during off-peak hours to avoid affecting network services.
  • Service configuration data is planned on eSight and then applied to devices in batches. If you use other methods to modify device configuration, the configuration on the eSight may be inconsistent with that on devices.
  • Only configuration using service templates is supported. If the AS stays in independent configuration mode, switch it to the service template mode.
  • The service template must be configured correctly. Otherwise, provisioning of SVF configuration data may make the AS go offline unexpectedly.
  • If the AS is connected to the root device through a service port, run the stp disable command in the service port view. Otherwise, the root device will be disconnected from eSight when the SVF enabling template is delivered. If the AS is connected to the root device through a management port, this problem does not occur.
Updated: 2019-09-07

Document ID: EDOC1100011877

Views: 311152

Downloads: 635

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next