No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R009C00 Operation Guide 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IP PBXs in Batches

Configuring IP PBXs in Batches

You can configure SIP trunks, active and standby servers, and software parameters for IP PBXs in batches.


  • The process for configuring SIP trunks is as follows:
    1. (Optional) Add an index for routing processing failures.
    2. Add office direction selection codes.
    3. Add office directions.
    4. Add number change indexes.
    5. Add prefixes.
    6. Add peer devices.
    7. Add SIP trunk groups.
  • The process for setting IP PBXs as local gateways is as follows:
    1. Set the type of active and standby servers to Localgw.
    2. Set the IP address of active server nodes.
    3. Set the IP address of standby server nodes.
  • Software parameters in this topic indicate parameters for the call forwarding on offline (CFO) service.


  1. Choose Resource > Collaboration > Collaboration Management > Network Element Device Management from the main menu.

  2. In the navigation tree, choose Network Element Device Management > Unified Communications > Business Configuration > IP PBX Batch Configuration.
  3. Optional: Add IP PBXs to the Devices to Configure area on the right.

    If the IP PBX you want to configure is included in the Devices to Configure area, skip this step.

    1. Click Add. The Select objects window is displayed.
    2. Choose a subnet from the navigation tree on the left. All managed IP PBXs on this subnet are displayed on the right.
    3. Select multiple IP PBXs and click OK.

  4. Choose the parameters to be configured from the navigation tree on the left.
  5. Select IP PBXs to be configured in Devices to Configure.
  6. Configure the related parameters as prompted.


The system starts to configure the selected IP PBXs in batches. The Result column shows the configuration result.

Updated: 2019-09-07

Document ID: EDOC1100011877

Views: 316378

Downloads: 639

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next