No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R009C00 Operation Guide 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Auto Discovery for Devices

Auto Discovery for Devices

You can apply the automatic device discovery function to discover devices in batches if all devices in an IP network segment need to be connected to and establish communication with the eSight. The function saves time.

Prerequisite

  • You have the operation rights for Access Resource.
  • Protocol settings have been complete. For details, see section "Resource Management > Adding Resources" in the eSight Operation Guide.
  • Virtual Manager (FS/FC/vCenter/ESX) has been installed.

Context

The eSight provides three automatic device discovery modes by network segment, by ARP, and by router. You can also add network segments or IP addresses of the devices that do not need to be discovered to an exclusion list. During automatic device discovery, the eSight automatically skips the network segments or IP addresses in the exclusion list.

Automatic discovery tasks are classified into one-off tasks and scheduled tasks. One-off tasks are executed immediately while you can determine whether to execute scheduled tasks immediately.

Procedure

  1. Plan the automatic device discovery mode, discovery task type, and exclusion list.
  2. Add the network segments or IP addresses of the devices that do not need to be discovered to the exclusion list. The task will automatically skip the network segments or IP addresses.

    1. Choose Resource > Common from the main menu.
    2. Choose Add Resource > Automatic Task Management in the navigation area on the left.
    3. On the Exclusion List tab page, create excluded network segments or IP addresses.

  3. Select an automatic device discovery method.

    1. Choose Resource > Common from the main menu.
    2. Choose Add Resource > Auto Discovery in the navigation area on the left.
    3. On the Auto Discovery page, click Change Discovery Mode in the upper right corner to select a desired mode.

  4. Set the tasks of an automatic discovery task and create the task.
  5. Confirm the discovery results.

    • You can immediately view the results for the task with type as One-off and the scheduled task that is immediately executed.
    • For the scheduled task that is not immediately executed
    1. choose Resource > Common from the main menu,
    2. Choose Add Resource > Automatic Task Management in the navigation area on the left.
    3. View the discovery results in Discovered Device List.

Download
Updated: 2019-05-17

Document ID: EDOC1100011877

Views: 287152

Downloads: 550

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next