No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R009C00 Operation Guide 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding Devices to eSight

Adding Devices to eSight

eSight can manage the NDE device, for example, obtaining information from the NDE device, only after you add the device to it.




1. Set protocol parameters on the device: (NetStream and SNMP)

NetStream parameter settings vary with the device type, and are not described in detail here. If you are not clear about settings, choose Traffic Config > Navigation and click to view the configuration.

For details about how to configure the SNMP protocol on the device, see Configuring the SNMP Protocol on Devices.

2. Add devices to eSight.

eSight can manage devices and monitor interfaces on the devices, APs connected to the devices, and the VXLAN tunnels only after you add the devices to it.

For details about how to add devices to eSight, see Adding Devices to eSight.

Updated: 2019-09-07

Document ID: EDOC1100011877

Views: 310104

Downloads: 633

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next