No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SUN2000-(50KTL, 60KTL, 65KTL)-M0 User Manual

This document describes the SUN2000-50KTL-M0, SUN2000-60KTL-M0 and SUN2000-65KTL-M0 in terms of its installation, electrical connections, commissioning, maintenance, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the SUN2000

Installing the SUN2000

Installation Precautions

Before installing the SUN2000, take it out from the packing case and move it to the installation position.

Figure 4-15 Taking out a SUN2000

To prevent device damage and personal injury, keep balance when moving the SUN2000 because it is heavy.

  • Move the SUN2000 with the help of other three persons or using an appropriate transportation tool.
  • Do not use the ports and wiring terminals at the bottom to support any weight of the SUN2000.
  • When you need to temporarily place the SUN2000 on the ground, use foam, paper, or other protection material to prevent damage to its enclosure.

Procedure

  1. If you can mount the SUN2000 onto the mounting bracket directly, go to 3 and then 5.
  2. If you cannot mount the SUN2000 onto the mounting bracket directly, go to 3 and then 6.
  3. Lift the SUN2000 and turn it upright.

    To prevent device damage and personal injury, keep balance when raising the SUN2000 because it is heavy.

  4. Run a lifting sling through the lifting eyes of the SUN2000.

    When lifting the SUN2000, keep balance to prevent the SUN2000 impacting with a wall or other objects.

    Figure 4-16 Lifting a SUN2000
    NOTE:

    The figure is for reference only.

  5. Install the SUN2000 on the mounting bracket.

    Figure 4-17 Mounting the SUN2000 onto a mounting bracket

  6. Tighten the two antitheft screws using a security torx wrench.

    Figure 4-18 Tightening antitheft screws

Updated: 2019-10-12

Document ID: EDOC1100016052

Views: 7950

Downloads: 2284

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next